LFO module provides 4 outputs, 3 with phase shift.
The PH S knob controls phase:

center = no shift,

up = maximum shift (45° / 90° / 180° depending on output),

down = the same amount but in the opposite direction.

RATE controls LFO speed.
WAVE smoothly morphs between waveforms inside the selected bank.

BANK button:

• Short press: switch between waveform banks (5 banks + 1 bonus).

• Hold: enter rate range selection mode.
  In this mode, short press cycles rate ranges:
  0.05–10 Hz, 0.05–5 Hz, 0.05–3 Hz.
  Hold again to exit back to bank mode.

There are CV inputs with attenuators for WAVE, RATE, and PHASE.

Range switch selects output voltage range:
0 to +10 V or –5 to +5 V.

• manual
• ModularGrid